2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the cylinder block drain cock plug.

    A112179E01


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. REMOVE NO. 1 ENGINE COVER

  1. A124558
    Remove the 2 nuts and engine cover.


4. REMOVE AIR CLEANER CAP

  1. A124559
    Disconnect the mass air flow meter connector.

  1. Disconnect the purge VSV connector.

  1. Disconnect the 4 wire harness clamps.

  1. A124560
    Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Disconnect the purge line hose from the clamp.

  1. A124561
    Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

  1. A124562
    Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


5. REMOVE THROTTLE BODY

  1. A124564
    Disconnect the purge line hose from the throttle body.

  1. Disconnect the water by-pass hose from the throttle body.

  1. Disconnect the No. 2 water by-pass hose from the throttle body.

  1. Disconnect the No. 1 throttle body hose from the throttle body.

  1. Disconnect the throttle position sensor and control motor connector.

  1. Disconnect the wire harness clamp.

  1. Disconnect the fuel tube from the clamp.

  1. A124565
    Remove the 4 bolts, and then remove the fuel pipe support and throttle body.

  1. A124566
    Remove the gasket from the intake manifold.

← ON-VEHICLE INSPECTION (from Nov 2005)INSPECTION (from Nov 2005) →