2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL ECM

  1. A124573
    Install the 2 brackets to the ECM with the 4 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }

  1. A124572
    Connect the 2 ECM connectors.

    NOTICE:
    When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and other part.


    1. Connect the 2 ECM connectors and lower the 2 levers.

      NOTICE:
      Make sure that the 2 levers are securely locked.

  1. A124570
    Install the ECM with the 3 bolts.

    Torque:
    6.5 N*m{ 66 kgf*cm , 57 in.*lbf }


2. INSTALL AIR CLEANER CASE

  1. A137898
    Install the air cleaner case with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the harness clamp.


3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner filter element onto the air cleaner case.

  1. A137901E01
    Insert the hinge part of the air cleaner cap into the air cleaner case, then hang the 2 hook clamps.

  1. A173728
    Tighten the No. 1 air cleaner hose clamp.

  1. Connect the No. 2 ventilation hose to the air cleaner hose.

  1. Connect the 2 wire harness clamps and 2 vacuum hoses.

  1. Connect the VSV (intake air control) connector.

  1. Connect the mass air flow meter connector.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. PERFORM REGISTRATION
  1. When replacing the ECM, perform the vehicle stability control system recognition in the ECM (Click here).


6. RESET MEMORY
  1. When replacing the ECM, perform the RESET MEMORY procedure (A/T initialization) (Click here).

← REMOVAL (from Aug 2007)COMPONENTS (from Aug 2007) →