2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE AIR CLEANER CAP

  1. A124559
    Disconnect the mass air flow meter connector.

  1. Disconnect the purge VSV connector.

  1. Disconnect the 4 wire harness clamps.

  1. A124560
    Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Disconnect the purge line hose from the clamp.

  1. A124561
    Squeeze the tabs of the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

  1. A124562
    Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE AIR CLEANER CASE

  1. A124563
    Disconnect the harness clamp.

  1. Remove the 3 bolts and air cleaner case.


4. REMOVE ECM

  1. A124570
    Remove the 3 bolts from the ECM with brackets.

  1. A124571E01
    Disconnect the 2 ECM connectors.

    NOTICE:
    After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.


    1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.

  1. Remove the ECM with brackets.

  1. A124573
    Remove the 4 screws and 2 ECM brackets.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →