2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

A079305E04
  1. Using a vernier caliper, measure the brush length.

    Standard length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

A097476E02

  1. Check the resistance.

    1. Measure the resistance between the slip rings.

      Standard resistance:
      2.3 to 2.7 Ω at 20°C (68°F)

      If the result is not as specified, replace the generator rotor assembly.

    2. A097477E02
      Measure the resistance between the slip ring and rotor core.

      Standard resistance:
      1 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.

  1. A097470E02
    Check the slip ring diameter.

    1. Using a vernier caliper, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.4 mm (0.559 to 0.567 in.)

      Minimum diameter:
      14 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.

  1. A097469E01
    Check the appearance.

    1. Check that the bearing is not rough or worn.

      OK:
      The bearing rotates smoothly.

      If the result is not as specified, replace the generator rotor assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING

A097471E01
  1. Check that the bearing is not rough or worn.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the generator assembly.

← DISASSEMBLY (from Nov 2005)REPLACEMENT (from Nov 2005) →