2005-2008 RAV4 · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE GENERATOR PULLEY

A097454E02
SST
09820-63011   (09820-06010)
09820-06021  
  1. Tighten SST 1-B to the specified torque, and then fix SST 1-A on the generator rotor shaft.

    Item
    Part No.
    SST 1-A and B
    09820-06010
    SST 2
    09820-06021

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Securely fix SST on the generator rotor shaft.

  1. A097455E02
    Clamp SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and then fix the generator pulley nut into SST 2.

  1. A097456E02
    Turn SST 1-A in the direction shown, and then loosen the generator pulley nut.

    NOTICE:
    If the generator pulley nut is turned by more than a half turn, the generator rotor shaft may be damaged.

  1. Remove the generator from SST 2.

  1. A097458E02
    Fix SST 1-B in place, and then loosen SST 1-A in the direction shown. Remove SST 1-A and B from the generator.

  1. A097459E01
    Remove the generator pulley nut and generator pulley.


2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A130331
    Remove the 3 nuts and generator rear end cover.

  1. A097461E01
    Remove the terminal insulator.

  1. A097462E01
    Remove the 2 screws and generator brush holder.


3. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A097464E01
    Remove the bolt and cord clip.

  1. A097465E01
    Remove the 4 bolts.

  1. A122144E01
    Using SST, remove the coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010)

  1. Remove the generator rotor from the generator.

  1. Remove the washer.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →