REMOVAL
Removal / installation · Vehicles built from Aug 2007
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
Remove the 9 clips and cover.

| 2. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Turn the A/C switch ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, discharge the refrigerant gas.
- SST
- 07110-58060
(07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation (Click here).
| 4. REMOVE V-BANK COVER SUB-ASSEMBLY |
Detach the 3 clips and remove the V-bank cover.

| 5. DISCONNECT RADIATOR RESERVE TANK ASSEMBLY |
Remove the 2 bolts and disconnect the reservoir tank.

| 6. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 2 bolts, 4 screw, 10 clips and under cover.
| 7. REMOVE REAR ENGINE UNDER COVER RH |
Remove the 2 clips and under cover.
| 8. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH |
Remove the 4 bolts and reinforcement.

| 9. REMOVE V-RIBBED BELT |
Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.

While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.

| 10. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE |
![]() ![]() |
Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant suction hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
| 11. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() ![]() |
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
| 12. REMOVE COOLER COMPRESSOR ASSEMBLY |
Disconnect the connector.

Remove the 4 bolts and cooler compressor.


