DISASSEMBLY
Removal / installation · Vehicles built from Aug 2007
| 1. REMOVE MAGNETIC CLUTCH ASSEMBLY |
Place the compressor and magnetic clutch in a vise.

Using locking pliers, hold the magnetic clutch hub.
Remove the bolt, magnetic clutch hub, and magnetic clutch washers.
- HINT:
- There is no set number of magnetic clutch washers because they are used for adjustment.
Using a snap ring expander, remove the snap ring and then remove the magnetic clutch rotor.

- NOTICE:
- Take care not to damage the seal cover of the bearing when removing the snap ring.
Disconnect the connector.
Remove the screw.
Using a snap ring expander, remove the snap ring and magnetic clutch stator.

