REMOVAL
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Jan 2007 – Jul 2007 from Aug 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE ENGINE ASSEMBLY |
 |
Remove the engine assembly from the vehicle (Click here).
| 3.
REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR
|
 |
- Remove the 5 bolts and manifold converter insulator.
| 4.
REMOVE NO. 2 MANIFOLD CONVERTER INSULATOR
|
 |
- Remove the 3 bolts and manifold converter insulator.
| 5.
REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
|
 |
- Disconnect the 2 exhaust gas temperature sensor connectors.
- Remove the bolt, nut and No. 1 manifold stay.
- Remove the 3 bolts and No. 2 manifold stay.
- Remove the 2 bolts, nut and No. 2 exhaust manifold stay.
- Remove the 3 nuts, manifold converter and gasket.
| 6.
SEPARATE NO. 2 WATER BY-PASS HOSE |
 |
- Using pliers, grip the claw of the clip and slide the clip to separate the No. 2 water by-pass hose.
- HINT:
- Place a container under the connection before separating the No. 2 water by-pass hose because coolant in the hose may spill out.
| 7.
REMOVE EGR COOLER ASSEMBLY |
 |
- Disconnect the vacuum hose from the No. 2 EGR valve.
- Remove the 4 bolts.
Remove the 2 bolts, 2 nuts, EGR cooler, 2 gaskets and O-ring.
- Remove the 2 bolts and 2 nuts.
Disassemble the No. 1 EGR pipe, No. 2 EGR valve, EGR cooler and 2 gaskets.