2005-2008 RAV4 · Service Manual ENGINE

P0191 Fuel Rail Pressure Sensor Circuit Range / Performance

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The ECM monitors the internal fuel pressure of the common rail using the fuel pressure sensor, and controls the suction control valve to regulate the common rail pressure to the target pressure determined by the ECM. The pressure sensor is a semiconductor that varies its electrical resistance when pressure is applied to its silicon chip. This sensor outputs a voltage in proportion to the common rail fuel pressure.
C129048E01
DTC No.
DTC Detection Condition
Trouble Area
P0191
Voltage output of the fuel pressure sensor for the common rail is out of the standard range
(1 trip detection logic)
Fuel pressure sensor

INSPECTION PROCEDURE

HINT:
If DTCs P0087, P0190, P0192, and P0193 are output simultaneously, the manifold absolute pressure sensor circuit may be open or short. Perform troubleshooting for these DTCs first.


1. CHECK OTHER DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    P0191
    A
    P0191 and other DTCs
    B

    HINT:
    If codes other than P0191 are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART
A

REPLACE COMMON RAIL ASSEMBLY (FUEL PRESSURE SENSOR)


← P0180 Fuel Temperature Sensor "A" Circuit (+ P0182, P0183) (from Jan 2007)P0200 Injector Circuit / Open (Nov 2005 – Dec 2006) →