2005-2008 RAV4 · Service Manual ENGINE

P0560 System Voltage

Diagnostic trouble codes · Vehicles built from Jan 2007

DESCRIPTION

While the ignition switch is off, battery voltage is supplied to terminal BATT of the ECM for storing DTCs and fuel injection feedback learning values.
DTC No.
DTC Detection Condition
Trouble Area
P0560
Condition (a) or (b) continues:
(a) Significant decrease in battery voltage
(b) Open in back-up power source circuit (1 trip detection logic)
  1. Open in back-up power source circuit
  2. Low battery voltage
  3. ECM

HINT:
If DTC P0560 appears, the ECM does not store other DTCs.


WIRING DIAGRAM

C128769E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (ECM - INTEGRATION RELAY)

  1. A128699E02
    Disconnect the ECM connector.

  1. Remove the intelligent relay from the engine room No. 1 relay block.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A12-2 (BATT) - 1A-1
    Below 1 Ω
    A12-2 (BATT) or 1A-1 - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reinstall the integration relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← P0544 Exhaust GAS Temperature Sensor Circuit (Bank 1 Sensor 1) (+ 5 more codes) (from Aug 2007)P0606 ECM / PCM Processor (+ P0607, P1611) (Jan 2007 – Jul 2007) →