2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

TERMINALS OF ECU

System information · Vehicles built from Nov 2005


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER
F100629E04
  1. Disconnect the E64 ECU connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG (E64-1) - GND (E64-9)
    L - W-B
    IG power source
    Ignition switch on (IG)
    10 to 14 V
    Ignition switch off
    Below 1 V
    GND (E64-9) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E64 ECU connector.

  4. Measure the voltage of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    SPD (E64-3) - GND (E64-9)
    V - W-B
    Vehicle speed signal
    Vehicle is running
    Pulse generation
    SIL (E64-4) - GND (E64-9)
    W - W-B
    Diagnosis tester communication line
    Ignition switch on (IG),
    when communication is not performed with a tester
    8 to 15 V
    IND (E64-5) - GND (E64-9)
    P - W-B
    Tire pressure warning light output signal
    Ignition switch IG (on),
    tire pressure warning light ON
    Below 0.5 V
    TC (E64-10) - GND (E64-9)
    G - W-B
    TC terminal
    When terminal TC is not connected
    8 to 15 V
    If the result is not as specified, the ECU may have a malfunction.

← PROBLEM SYMPTOMS TABLE (from Nov 2005)DIAGNOSIS SYSTEM (from Nov 2005) →