C2191/91 Vehicle Speed Signal Error (Test Mode DTC)
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The tire pressure monitor ECU and receiver receives a speed signal from the combination meter. This DTC is stored upon entering test mode but erased when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The DTC is output only in test mode.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C2191/91 |
Speed sensor circuit malfunction |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Check the Data List for proper functioning of the vehicle speed signal.
Tire pressure warning ECU and receiver Item
Measurement item / Range(Display)
Normal Condition
Diagnostic Note
Vehicle Sped
Vehicle speed reading /
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
Speed indicated on the combination meter
- OK:
- Indicates actual speed.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (ECU - METER) |
![]() ![]() |
Disconnect the E64 ECU connector.
Disconnect the E22 meter connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E64-3 (SPD) - E22-39 (+S)
Below 1 Ω
E64-3 (SPD) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK TIRE PRESSURE WARNING ECU AND RECEIVER |
![]() ![]() |
Measure the voltage of the ECU connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E64-3 (SPD) - E64-9 (GND)
While driving vehicle
Pulse generation
- HINT:
- As the vehicle speed (wheel revolution speed) increases, the cycle of the waveform narrows.
|
|
||||
| OK | ||
| ||


