REGISTRATION
Other · Vehicles built from Nov 2005
| 1. IN CASE OF TIRE PRESSURE WARNING ECU AND RECEIVER REPLACEMENT |
Read ID stored in the old ECU using the intelligent tester.
| 2. IN CASE OF TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
Read the ID written on the tire wheel.
| 3. REGISTER TRANSMITTER ID |
- NOTICE:
- It is necessary to register the transmitter ID in the tire pressure warning ECU and receiver when replacing the tire wheel and/or tire pressure warning ECU and receiver.
Prepare all of the transmitter ID data before starting registration.
- HINT:
- Read the registered transmitter IDs that are stored in the ECU using the intelligent tester and make a note of them.
- If reading stored transmitter IDs is impossible due to malfunctions of components such as the tire pressure warning antenna and receiver, replace the tire wheel.
- When replacing the tire wheel, wriee down the IDs from the sticker on the inside surface of the tire wheel.
- Read the registered transmitter IDs that are stored in the ECU using the intelligent tester and make a note of them.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
*1: Read and write down the ID (ID1 to ID4) by using the Data List.

*2: Select REGIST TIRE SET following the intelligent tester screen (UTILITY - REGIST TIRE SET).

*3: Select the registration mode "MAIN".
Input the ID (ID1 to ID4) using the intelligent tester and transmit it to the tire pressure warning ECU and receiver.

Set the ID transmission condition to "ID Registration is complete".


- HINT:
- The previously registered IDs will be deleted from the memory when the registration is completed.
- If the operations of *1 to *3 are not completed within 5 minutes, the mode will return to normal operation mode.
- The previously registered IDs will be deleted from the memory when the registration is completed.
| 4. CONFIRMATION OF TRANSMITTER ID REGISTRATION |
Set the tire pressure of all wheels (including the spare tire) to the specified value.
- Standard pressure:
- 220 kPa (2.2 kgf/cm2, 32 psi)
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select "SIGNAL CHECK" mode on the intelligent tester (Click here).
Confirm that the transmitter IDs and tire pressure data for all the tires are displayed on the intelligent tester screen.
- NOTICE:
- It may take up to 1 minute to update the tire pressure data.
- If the IDs have not been registered, DTC C2171/71 is set in the tire pressure warning ECU and receiver after approximately 60 minutes.
- It may take up to 1 minute to update the tire pressure data.
