TC and CG Terminal Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking of the tire pressure warning light.WIRING DIAGRAM


- HINT:
- When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU may have occurred.
INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (DLC3 - ECU) |
![]() ![]() |
Disconnect the E16 DLC3 connector.
Disconnect the E64 ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E16-13 (TC) - E64-10 (TC)
Below 1 Ω
E16-4 (CG) - Body ground
|
|
||||
| OK | ||
| ||

