2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

F101030E04

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG1)
  1. Remove the ECU-IG1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT IG1 RELAY
A092673E31
  1. Remove the IG1 relay from the instrument panel junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω
    (When battery voltage is applied to terminals 1 and 2)



NG
REPLACE IG1 RELAY
OK


3. CHECK WIRE HARNESS (ECU - BATTERY AND BODY GROUND)
F101029E02
  1. Disconnect the E64 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E64-1 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    Ignition switch off
    Below 1 V

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E64-9 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Tire Pressure Warning Light Circuit (from Nov 2005)TC and CG Terminal Circuit (from Nov 2005) →