REMOVAL
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Jan 2007 – Jul 2007 from Aug 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE ENGINE ASSEMBLY |
 |
Remove the engine assembly from the vehicle (Click here).
| 3.
REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR |
 |
- Remove the 5 bolts and manifold converter insulator.
| 4.
REMOVE NO. 2 MANIFOLD CONVERTER INSULATOR |
 |
- Remove the 3 bolts and manifold converter insulator.
| 5.
REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY |
 |
- Disconnect the 2 exhaust gas temperature sensor connectors.
- Remove the bolt, nut and No. 1 manifold stay.
- Remove the 3 bolts and No. 2 manifold stay.
- Remove the 2 bolts, nut and No. 2 exhaust manifold stay.
- Remove the 3 nuts, manifold converter and gasket.
| 6.
REMOVE NO. 1 VACUUM TRANSMITTING HOSE ASSEMBLY |
 |
- Using pliers, grip the claws of the clip and slide the clip to remove the vacuum transmitting hose.
| 7.
REMOVE NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY |
 |
- Using pliers, grip the claws of the clip and slide the clip to remove the No. 2 vacuum transmitting hose.
| 8.
REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Front Side)
|
 |
- Using SST, loosen the union nut and remove the sensor from the manifold converter.
- SST
- 09023-38401
| 9.
REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Rear Side)
|
 |
- Using SST, loosen the union nut and remove the sensor from the manifold converter.
- SST
- 09023-38401
- Remove the 2 bolts and sensor.
| 10.
REMOVE NO. 1 VACUUM PIPE |
 |
- Using SST, loosen the union nut and disconnect the vacuum pipe nut from the manifold converter.
- SST
- 09023-38401
- Remove the bolt and vacuum pipe.
| 11.
REMOVE NO. 2 VACUUM PIPE |
 |
- Using SST, loosen the union nut and disconnect the vacuum pipe from the manifold converter.
- SST
- 09023-38401
- Remove the bolt and vacuum pipe.