2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Jan 2007 – Jul 2007 from Aug 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE ENGINE ASSEMBLY
  1. Remove the engine assembly from the vehicle (Click here).


3. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR

  1. A114857
    Remove the 5 bolts and manifold converter insulator.


4. REMOVE NO. 2 MANIFOLD CONVERTER INSULATOR

  1. A114858
    Remove the 3 bolts and manifold converter insulator.


5. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

  1. A110771
    Disconnect the 2 exhaust gas temperature sensor connectors.

  1. A160474
    Remove the bolt, nut and No. 1 manifold stay.

  1. A110790
    Remove the 3 bolts and No. 2 manifold stay.

  1. A110768
    Remove the 2 bolts, nut and No. 2 exhaust manifold stay.

  1. A110789
    Remove the 3 nuts, manifold converter and gasket.


6. REMOVE NO. 1 VACUUM TRANSMITTING HOSE ASSEMBLY

  1. A114860
    Using pliers, grip the claws of the clip and slide the clip to remove the vacuum transmitting hose.


7. REMOVE NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY

  1. A114861
    Using pliers, grip the claws of the clip and slide the clip to remove the No. 2 vacuum transmitting hose.


8. REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Front Side)

  1. A116325E02
    Using SST, loosen the union nut and remove the sensor from the manifold converter.
    SST
    09023-38401  


9. REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Rear Side)

  1. A116326E01
    Using SST, loosen the union nut and remove the sensor from the manifold converter.
    SST
    09023-38401  

  1. A116327
    Remove the 2 bolts and sensor.


10. REMOVE NO. 1 VACUUM PIPE

  1. A114865E01
    Using SST, loosen the union nut and disconnect the vacuum pipe nut from the manifold converter.
    SST
    09023-38401  

  1. A114866
    Remove the bolt and vacuum pipe.


11. REMOVE NO. 2 VACUUM PIPE

  1. A114867E01
    Using SST, loosen the union nut and disconnect the vacuum pipe from the manifold converter.
    SST
    09023-38401  

  1. A114868
    Remove the bolt and vacuum pipe.

← REMOVAL (Jan 2007 – Jul 2007)INSTALLATION (Jan 2007 – Jul 2007) →