DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1.
REMOVE SELECTING BELL CRANK ASSEMBLY |
 |
- Remove the 2 bolts and selecting bell crank from the transmission case.
| 2.
REMOVE CONTROL SHIFT LEVER BUSH |
 |
- Remove the control shift lever bush from the selecting bellcrank.
| 3.
REMOVE NO. 1 SELECTING BELLCRANK DUST COVER |
 |
- Remove the dust cover from the selecting bellcrank.
| 4.
REMOVE BACK-UP LIGHT SWITCH ASSEMBLY |
 |
- Using SST, remove the back-up light switch and gasket.
- SST
- 09816-30010
| 5.
REMOVE NO. 1 LOCK BALL ASSEMBLY |
 |
- Remove the lock ball from the transmission case.
| 6.
REMOVE NO. 2 LOCK BALL ASSEMBLY |
 |
- Remove the lock ball from the transmission case.
| 7.
REMOVE SHIFT GATE PIN |
 |
- Remove the shift gate pin from the transmission case.
| 8.
REMOVE CONTROL SHAFT COVER |
 |
- Remove the 4 bolts and control shaft cover from the transmission case.
| 9.
REMOVE NO. 1 SHIFT LEVER INNER |
 |
- Using a pin punch and hammer, tap out the slotted spring pin from the No.1 shift lever inner.
Remove the No. 1 shift lever inner and shift inter lock plate from the shift and select lever shaft.
| 10.
REMOVE SHIFT AND SELECT LEVER SHAFT |
 |
- Remove the shift control cover and the shift and select lever boot from the shift and select lever shaft.
| 11.
REMOVE SHIFT GATE PLATE |
 |
- Remove the 2 bolts and shift gate plate from the No. 1 shift lever inner.
| 12.
REMOVE PIN |
 |
- Remove the 2 pins.
| 13.
REMOVE SHIFT LEVER DAMPER |
 |
- Remove the 2 bolts and shift lever damper from the shift lever shaft.
| 14.
REMOVE CONTROL SHAFT COVER OIL SEAL |
 |
- Using a screwdriver, pry out the oil seal from the control shaft cover.
| 15.
REMOVE SHIFT FORK SHAFT BEARING |
 |
- Using SST and a press, press out the bearing.
- SST
- 09285-76010