REMOVAL
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE ENGINE ASSEMBLY |
 |
Remove the engine from the vehicle (Click here).
| 3.
REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR |
 |
- Remove the 5 bolts and No.1 manifold converter insulator.
| 4.
REMOVE NO. 2 MANIFOLD CONVERTER INSULATOR |
 |
- Remove the 3 bolts and No.2 manifold converter insulator.
| 5.
REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY |
 |
- Disconnect the 2 exhaust gas temperature sensor connectors.
- Remove the bolt, nut and No.1 manifold stay.
- Remove the 3 bolts No.2 manifold stay.
- Remove the 2 bolts, nut and No.2 exhaust manifold stay.
- Remove the 3 nuts, manifold converter and turbine outlet elbow gasket.
| 6.
REMOVE NO. 1 TURBO INSULATOR |
 |
- Remove the 2 bolts, and then remove the insulator.
| 7.
REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY |
 |
- Using needle-nose pliers, grip the claws of the clip and slide the clip to disconnect the No. 1 turbo water hose.
- HINT:
- Place a container under the connection before disconnecting the No. 1 turbo water hose because water in the hose may spill out.
- Remove the bolt and gasket, then remove the pipe.
| 8.
REMOVE NO. 2 TURBO WATER PIPE SUB-ASSEMBLY |
 |
- Using needle-nose pliers, grip the claws of the clip and slide the clip to disconnect the No. 3 water by-pass hose.
- HINT:
- Place a container under the connection before disconnecting the No. 3 water by-pass hose because water in the hose may spill out.
- Remove the 2 bolts and gasket, and then remove the pipe.
| 9.
REMOVE TURBO OIL OUTLET PIPE |
 |
- Remove the 4 bolts and 2 gaskets, and then remove the pipe.
- HINT:
- Place a container under the connection before disconnecting the turbo oil outlet pipe because oil in the pipe may spill out.
| 10.
DISCONNECT NO. 2 TURBO OIL PIPE |
 |
- Remove the 2 bolts and 2 gaskets.
- Disconnect the 2 vacuum hoses to remove the turbo oil pipe.
| 11.
REMOVE TURBOCHARGER STAY |
 |
- Remove the 2 nuts and 2 spacers, and then remove the turbocharger stay.
| 12.
REMOVE TURBOCHARGER SUB-ASSEMBLY |
 |
- Remove the 3 nuts, turbocharger and gasket.
| 13.
REMOVE NO. 2 TURBO OIL PIPE |
|