2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2008


1. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A124671
    Install the sender gauge with the 5 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }


2. INSTALL NO. 1 FUEL TANK CUSHION

  1. A128746
    Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.


3. INSTALL AIR INLET LINE TUBE

  1. A178838
    Attach the 2 clamps to install the air inlet line tube to the fuel tank.


4. INSTALL NO. 1 FUEL TUBE CLAMP

  1. A124672
    Install the 4 tube clamps to the fuel tank.


5. INSTALL FUEL EVAPORATION TUBE SUB-ASSEMBLY
  1. Install the tube to the fuel tube clamps.


6. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
  1. Install the tube to the fuel tube clamps.


7. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY

  1. A126699E02
    Install a new gasket onto the fuel suction with pump.

  1. A202412E01
    Connect the fuel hose with the paint mark facing towards the top of the vehicle, and then secure the clip.

  1. Install the fuel suction with pump into the fuel tank.

    NOTICE:
    Do not damage the fuel suction with pump.


8. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


9. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124668
    Install the fuel tube with the joint clip.

    NOTICE:
    A124131E05
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
    5. Be careful not to damage the clip. If the clip is damaged, replace it.


10. INSTALL FUEL EMISSION HOSE

  1. A203591E01
    Connect the purge line hose, air inlet line hose to the fuel suction plate.

  1. Connect the fuel emission hose to the fuel suction plate.

    HINT:
    Firmly push the tube connector until a "click" sound is heard.

    NOTICE:
    1. Before connecting the hose, check if there is any damage or foreign matter in the hose or connector.
    2. Check that the connector is connected by pulling on it.

← DISASSEMBLY (from Aug 2008)INSTALLATION (Aug 2007 – Jul 2008) →