2005-2008 RAV4 · Service Manual STEERING

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


CHECK DTC

  1. B127990E01
    When using intelligent tester:

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and press the intelligent tester main switch ON.

    3. Read the DTCs by following the prompts on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  2. H100769E10
    When not using intelligent tester:

    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. Read and write down any DTCs indicated by the P/S warning light on the combination meter. Refer to the chart below for examples of a normal code and DTCs 21 and 22.
      B128060E03

      HINT:
      1. If the P/S warning light does not blink to display any DTCs set or the normal code, inspect the circuit shown in the table below.
        Trouble Area
        See procedure
        EPS warning light circuit
        Click here
      2. If 2 or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.

    4. Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.

  3. C129278E02
    w/ Multi-information Display
    When not using intelligent tester:

    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. Press the combination meter display switch to display the P/S column in the multi-display. DTCs will be output in the multi-display.

      HINT:
      When normal, the following are displayed: FF (for when there are no past malfunctions); and EE (for when there are past malfunctions).


CLEAR DTC

  1. H100769E03
    When using intelligent tester:

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and press the intelligent tester main switch ON.

    3. Clear the DTCs by following the prompts on the intelligent tester.

    4. Turn the ignition switch off.

    5. Disconnect the intelligent tester from the DLC3.

  2. When not using intelligent tester:

    1. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. Disconnect SST from terminal 4 (CG) and reconnect it, and repeat this procedure 4 times or more within 8 seconds.

    4. Check that the P/S warning light blinking pattern is the normal code.

    5. Turn the ignition switch off.

    6. Remove SST from the DLC3.

← DIAGNOSIS SYSTEM (from Aug 2008)DTC CHECK / CLEAR (from Aug 2008) →