2005-2008 RAV4 · Service Manual STEERING

EPS Warning Light Circuit

Circuit diagnosis · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

DESCRIPTION

If the power steering ECU detects a malfunction, the EPS warning light comes on. At this time, the power steering ECU stores a DTC in its memory.

WIRING DIAGRAM

C163557E01
C163558E01

INSPECTION PROCEDURE


1. CHECK DTC
  1. Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system.

    OK:
    CAN DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM
OK


2. READ VALUE USING INTELLIGENT TESTER (IG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and press the intelligent tester main switch ON.

  1. Select the item "IG power supply" in the Data List and read the value displayed on the intelligent tester.

    Power steering ECU:
    Item
    Item Description: Range (Display)
    Inspection Condition
    Specified Condition
    IG Power Supply
    ECU power source voltage:
    Min.: 0 V
    Max.: 20.1531 V
    Ignition switch on (IG)
    10 to 14 V

    OK:
    The normal condition value is displayed on the intelligent tester.



OK
Go to step 5
NG


3. INSPECT FUSE (ECU-IG1)
  1. Remove the ECU-IG1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
INSPECT SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


4. CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY)
F100916E02
  1. Disconnect the A2 and E21 ECU connectors.

  1. Measure the voltage of the wire harness side connectors.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (P/S INDICATOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and press the intelligent tester main switch ON.

  1. Operate the intelligent tester according to the steps on the display and select the Active test.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E21-5 (IG) - A2-2 (PGND)
    Ignition switch on (IG)
    10 to 14 V

    Combination meter 
    Item
    Test Details
    Diagnostic Note
    Indicat. EPS
    P/S indicator
    ON/OFF
    Confirm that the vehicle is stopped, engine idling

    OK:
    Indicator comes on.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE POWER STEERING ECU


← U0073/49 Control Module Communication Bus Off (+ U0100/41, U0129/42) (from Aug 2008)EPS Warning Light Circuit (from Aug 2008) →