2005-2008 RAV4 · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE GENERATOR PULLEY WITH CLUTCH
  1. Remove the pulley cap.

  1. B057312E01
    Set SST (A) and (B).
    SST
    09820-63020  

  1. A115800E02
    Clamp SST (A) in a vise.

  1. Set the generator to SST.

    HINT:
    Make sure that the generator and SST are perpendicular to one another.

  1. Loosen the pulley by turning SST (B) in the direction shown in the illustration.

  1. Remove the generator from SST.

  1. Remove the pulley from the rotor shaft.


2. REMOVE GENERATOR REAR END COVER

  1. A115798
    Remove the 3 nuts and end cover.

  1. Remove the terminal insulator.


3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A115794
    Remove the 2 screws and brush holder.


4. REMOVE GENERATOR COIL ASSEMBLY

  1. A115801
    Remove the 4 bolts.

  1. A115802E01
    Using SST, remove the coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)

  1. Remove the washer.


5. REMOVE GENERATOR ROTOR ASSEMBLY
← REMOVAL (from Aug 2007)INSPECTION (from Nov 2005) →