2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT GENERATOR PULLEY WITH CLUTCH

  1. A115803E01
    Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
    If the result is not as specified, replace the generator pulley with clutch.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. B012264E03
    Check the rotor for an open circuit.

    1. Measure the resistance between the slip rings.

      Standard resistance:
      Condition
      Specified Condition
      Approx. 20°C (68°F)
      2.3 to 2.7 kΩ

      If the resistance is not as specified, replace the rotor assembly.

  1. B012265E02
    Check the rotor for a short to ground.

    1. Measure the resistance between the slip ring and rotor.

      Standard resistance:
      Tester Connection
      Specified Condition
      Slip ring - Rotor
      1 MΩ or higher

      If the resistance is not as specified, replace the rotor assembly.

  1. Check that the slip rings are not rough or scored.
    If rough or scored, replace the rotor assembly.

  1. B012266
    Using a vernier caliper, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the rotor assembly.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. B016374E01
    Using a vernier caliper, measure the length of the exposed brushes.

    Standard exposed length:
    10.5 mm (0.413 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    If the exposed length is less than the minimum, replace the brush holder assembly.


INSPECT GENERATOR ROTOR BEARING
  1. Check that the bearing is not rough or worn.
    If necessary, replace the rotor assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING
  1. Check that the bearing is not rough or worn.
    If necessary, replace the bearing (Click here).

← DISASSEMBLY (from Nov 2005)REPLACEMENT (from Nov 2005) →