2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Install the rotor to the drive end frame.

  1. Place the washer on the rotor.


2. INSTALL GENERATOR COIL ASSEMBLY

  1. A115795E02
    Using SST and a press, slowly press the coil assembly onto the generator rotor bearing.
    SST
    09285-76010  

  1. A115801
    Install the coil assembly with the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }


3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A113845E01
    While pushing the 2 brushes into the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.

  1. Install the generator brush holder assembly with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder assembly.


4. INSTALL GENERATOR REAR END COVER

  1. A115796
    Install the terminal insulator.

    NOTICE:
    Be careful to install the terminal insulator as shown in the illustration.

  1. A115798
    Install the end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


5. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Temporarily install the pulley onto the rotor shaft.

  1. B057312E01
    Set SST (A) and (B).
    SST
    09820-63020  

  1. A117476E02
    Clamp SST (A) in a vise.

  1. Set the generator to SST.

    HINT:
    Make sure that the generator and SST are perpendicular to one another.

  1. Torque the pulley by turning SST (B) in the direction shown in the illustration.

    Torque:
    110.5 N*m{ 1,126 kgf*cm , 81 ft.*lbf }

  1. Remove the generator from SST.

  1. Check that the pulley rotates smoothly.

  1. Install the pulley cap.

← REPLACEMENT (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →