Apply a light coat of engine oil to the O-ring of the sensor.
Install the sensor with the bolt.
Torque:
8.8 N*m{
90 kgf*cm
, 78 in.*lbf
}
Connect the sensor wire harness clamp.
Connect the sensor connector to the bracket.
Connect the sensor connector.
2.
INSTALL GENERATOR ASSEMBLY
Install the generator with the 3 bolts.
Torque:
25 N*m{
255 kgf*cm
, 18 ft.*lbf
}
NOTICE:
Be careful that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator.