2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL CRANKSHAFT POSITION SENSOR

  1. A102906
    Apply a light coat of engine oil to the O-ring of the sensor.

  1. A133148
    Install the sensor with the bolt.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

  1. Connect the sensor wire harness clamp.

  1. Connect the sensor connector to the bracket.

  1. Connect the sensor connector.


2. INSTALL GENERATOR ASSEMBLY

  1. A127719
    Install the generator with the 3 bolts.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Be careful that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator.

  1. Connect the generator wire with the nut and bolt.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf } for nut
    7.7 N*m{ 79 kgf*cm , 68 in.*lbf } for bolt

  1. Install the terminal cap.

  1. Connect the generator connector.


3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
  1. Install the front drive shaft (Click here).


4. INSTALL FAN AND GENERATOR V BELT

  1. A123517E02
    Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    1. Make sure that the V-ribbed belt is set properly at each pulley.
    2. Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.


5. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

A129514E01
  1. Install the reinforcement with the 4 bolts.

    Torque:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }


6. INSTALL ENGINE UNDER COVER RH
  1. Install the engine under cover with the 2 clips.


7. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 12 clips and 4 bolts.


8. INSTALL NO. 1 ENGINE COVER

  1. A123518
    Attach the 4 clips to install the engine cover.


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSTALLATION (Nov 2005 – Dec 2006)INSTALLATION (from Aug 2007) →