2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


3. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts, 12 clips and engine under cover.


4. REMOVE ENGINE UNDER COVER RH
  1. Remove the 2 clips and engine under cover.


5. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

A129514E01
  1. Remove the 4 bolts and reinforcement.


6. REMOVE FAN AND GENERATOR V BELT

  1. A123517E02
    Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.


7. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
  1. Remove the front drive shaft (Click here).


8. REMOVE GENERATOR ASSEMBLY

  1. A127719
    Disconnect the generator connector.

  1. Remove the terminal cap.

  1. Remove the nut and bolt, and disconnect the generator wire.

  1. Remove the 3 bolts and generator.


9. REMOVE CRANKSHAFT POSITION SENSOR

  1. A133148
    Disconnect the sensor connector.

  1. Disconnect the sensor connector from the bracket.

  1. Disconnect the sensor wire harness clamp.

  1. Remove the bolt and sensor.

← REMOVAL (Nov 2005 – Dec 2006)REMOVAL (from Aug 2007) →