REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 1 ENGINE COVER
|
 |
- Detach the 4 clips and remove the engine cover.
| 3.
REMOVE NO. 1 ENGINE UNDER COVER
|
 |
Remove the 4 bolts, 12 clips and engine under cover.
| 4.
REMOVE ENGINE UNDER COVER RH
|
 |
Remove the 2 clips and engine under cover.
| 5.
REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
|
 |
Remove the 4 bolts and reinforcement.
| 6.
REMOVE FAN AND GENERATOR V BELT
|
 |
- Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
- SST
- 09216-42010
- NOTICE:
- Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.
| 7.
REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
 |
Remove the front drive shaft (Click here).
| 8.
REMOVE GENERATOR ASSEMBLY
|
 |
- Disconnect the generator connector.
Remove the terminal cap.
Remove the nut and bolt, and disconnect the generator wire.
Remove the 3 bolts and generator.
| 9.
REMOVE CRANKSHAFT POSITION SENSOR |
 |
- Disconnect the sensor connector.
Disconnect the sensor connector from the bracket.
Disconnect the sensor wire harness clamp.
Remove the bolt and sensor.