2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT DIESEL THROTTLE BODY ASSEMBLY
  1. Inspect the diesel throttle valve.

    1. Turn the ignition switch on (IG).

    2. Wait 5 seconds after turning the ignition switch off.

      HINT:
      Be sure to turn off the ignition switch before performing this inspection. The fully closed position of the diesel throttle valve is learned when the ignition switch is turned off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch on (IG).

    5. Turn the intelligent tester on.

    6. Enter the following menu items: Powertrain / Engine and ECT / Data List / Diesel Throttle Angle.

    7. Check that the value of "Diesel Throttle Angle" is within the specification.

      Standard diesel throttle angle:
      Tester Display
      Specified Condition
      Diesel Throttle Angle
      Throttle Angle: -5 to 5%

      If the result is not as specified, replace the throttle body.

    8. Enter the following menu items: Powertrain / Engine and ECT / Data List / Throttle Valve Fully Closed.

    9. Check that the value of "Throttle Valve Fully Closed" is within the specification.

      Standard throttle valve fully closed:
      Tester Display
      Specified Condition
      Throttle Valve Fully Closed
      Throttle valve fully closed: 14.25 to 21.25 deg

      If the result is not as specified, replace the throttle body.

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →