REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 1 ENGINE COVER
|
 |
- Detach the 4 clips and remove the engine cover.
| 3.
REMOVE NO. 1 ENGINE UNDER COVER
|
 |
Remove the 4 bolts, 12 clips and engine under cover.
| 4.
REMOVE NO. 3 AIR HOSE |
 |
- Loosen the 2 hose clamps.
Disconnect the No. 3 air hose from the No. 2 air tube and throttle body.
| 5.
REMOVE DIESEL THROTTLE BODY ASSEMBLY |
 |
- Disconnect the throttle position sensor connector.
Disconnect the throttle motor connector.
Remove the 2 nuts and 2 bolts, and then remove the diesel throttle body and gasket.