2005-2008 RAV4 · Service Manual BRAKE

Brake Warning Light does not Come ON

Circuit diagnosis · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

WIRING DIAGRAM

Refer to the brake warning light circuit (Click here).

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BRAKE WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the BRAKE warning light operates.

    Skid control ECU 
    Item (Display)
    Test Details
    Diagnostic Note
    Brake Warning Lamp
    Turns Brake warning light / ON or OFF
    Observe combination meter

    OK:
    The BRAKE warning light turns on or off.



OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


3. INSPECT COMBINATION METER
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← Brake Warning Light Remains ON (from Aug 2007)Brake Warning Light does not Come ON (Jan 2007 – Jul 2007) →