C1251/51 Open in Pump Motor Circuit
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008
DESCRIPTION
The motor relay drives the pump motor based on a signal from the skid control ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1251/51 |
When either condition below is met:
|
|
WIRING DIAGRAM
Refer to DTC C0273/13, C0274/14, C1361/91 (Click here).INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Select the Active Test, generate a control command, and then check that the ABS motor relay operates.
Skid control ECU Item
Test Details
Diagnosis Note
Motor Relay
Turn ABS motor relay ON / OFF
Operation sound of motor can be heard
- OK:
- Operation sound of ABS motor is heard.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 6 km/h (4 mph) or more for several seconds.
Check if the same DTC is output (Click here ).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
| 3. INSPECT FUSE (ABS1) |
Remove the ABS1 H-fuse from the engine room No. 1 relay block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
Disconnect the A26 connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
A26-32 (GND1) - Body ground
Below 1 Ω
A26-1 (GND2) - Body ground
Below 1 Ω
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
A26-2 (BM) - Body ground
10 to 14 V
|
|
||||
| OK | ||
| ||
