2005-2008 RAV4 · Service Manual BRAKE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008


CHECK DTC (When Using Intelligent Tester)

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the tester on.

  4. Read the DTCs by following the prompts on the tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC (When Using Intelligent Tester)

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Turn the tester on.

  4. Operate the intelligent tester to clear the codes.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CHECK DTC (When not Using Intelligent Tester)

  1. H100769E17
    Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
    SST
    09843-18040  

  2. Turn the ignition switch on (IG).

  3. w/o Multi-information display:
    Read DTCs from the ABS warning light and VSC warning light on the combination meter.

  4. w/ Multi-information display:
    Read DTCs from the ABS warning light and the multi-information display on the combination meter.

    HINT:
    1. If no code appears, check the TC terminal circuit, ABS warning light circuit or VSC warning light circuit.
      Trouble Area
      See Procedure
      ABS warning light circuit
      Click here or Click here
      VSC warning light circuit
      Click here or Click here
      TC and CG Terminal Circuit
      Click here

    2. As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 31 and 43 for the ABS and VSC, and display of the normal system code and trouble code 31 and 43 for the ABS and VSC on the multi-information display.

      C130997E01
    3. DTCs are explained in the "DIAGNOSTIC TROUBLE CODE CHART" (Click here).

  5. After completing the check, disconnect SST from terminals 13 (TC) and 4 (CG) of the DLC3, and turn the ignition switch off.

    HINT:
    1. If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.


CLEAR DTC (When not Using Intelligent Tester)

  1. H100769E17
    Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
    SST
    09843-18040  

  2. Turn the ignition switch on (IG).

  3. C135697
    Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.

  4. Check that the ABS and VSC warning lights come on.

  5. Remove SST from the terminals of the DLC3.

  6. Turn the ignition switch off.

    HINT:
    Clearing the DTCs cannot be performed by removing the cable from the negative (-) battery terminal or the ECU-IG1 fuse.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch on (IG).

  2. Check that the ABS and VSC warning lights go off within approximately 3 seconds.

  3. Turn the ignition switch off.

← DIAGNOSIS SYSTEM (from Aug 2008)DTC CHECK / CLEAR (Jan 2007 – Jul 2007) →