2005-2008 RAV4 · Service Manual BRAKE

C1251/51 Open in Pump Motor Circuit

Diagnostic trouble codes · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

The motor relay (semiconductor relay) is housed in the skid control ECU and drives the pump motor based on a signal from the skid control ECU.
DTC No.
DTC Detection Condition
Trouble Area
C1251/51
When either condition below is met:
  1. Actuator pump motor does not operate properly.
  2. Open in actuator pump motor circuit continues for at least 2 seconds.
  1. Wire harness
  2. Brake actuator

WIRING DIAGRAM

Refer to DTC C0226/21, C0236/22, C0246/23, C0256/24 (Click here).

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY)
  1. Select the Active Test, generate a control command, and then check that the ABS motor relay operates.

    Skid control ECU 
    Item
    Vehicle Condition / Test Details
    Diagnosis Note
    Motor Relay
    Turn ABS motor relay ON / OFF
    Operation sound of motor can be heard

    OK:
    Operation sound of ABS motor is heard.



NG
Go to step 3
OK


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 6 km/h (4 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE BRAKE ACTUATOR ASSEMBLY

3. INSPECT FUSE (ABS1)
  1. Remove the ABS1 fuse from the engine room No. 1 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


4. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)

  1. C117862E06
    Disconnect the A27 connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    A27-23 (+BM) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← C1251/51 Open in Pump Motor Circuit (Nov 2005 – Dec 2006)C1251/51 Open in Pump Motor Circuit (from Aug 2007) →