P1625 Idle Signal Transmitter Circuit
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
The ECM reduces injector operation speed and applied voltage to the injector to reduce the sound it produces during idling. To do this, the ECM outputs applied voltage switching signals to terminal IJEN of the EDU from terminal IDLO of the ECM.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P1625 |
When either condition below is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
| 1. CHECK WIRE HARNESS (EDU - ECM) |
Disconnect the B51 EDU connector.

Disconnect the B32 ECM connector.
Measure the resistance of the wire harness connectors.
- Standard resistance:
Tester Connection
Specified Condition
B51-2 (IJEN) - B32-62 (IDLO)
Below 1 Ω
B51-2 (IJEN) - B32-62 (IDLO) - Body ground
10 kΩ or higher
Reconnect the EDU connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 2. REPLACE EDU |
Replace the EDU (Click here).
| NEXT | |
| 3. CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear DTCs (Click here).
Start the engine and drive the vehicle for approximately 15 minutes.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
- Result:
Display (DTC Output)
Proceed to
P1625
A
No output
B
|
|
||||
| NG | ||
| ||
