2005-2008 RAV4 · Service Manual ENGINE

P1625 Idle Signal Transmitter Circuit

Diagnostic trouble codes · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

DESCRIPTION

The ECM reduces injector operation speed and applied voltage to the injector to reduce the sound it produces during idling. To do this, the ECM outputs applied voltage switching signals to terminal IJEN of the EDU from terminal IDLO of the ECM.
DTC No.
DTC Detection Condition
Trouble Area
P1625
When either condition below is met:
  1. With the engine running at idle, voltage of the ECM IDLO terminal is 0.05 V or less for 3 seconds or more.
  2. With the engine running at speeds higher than idle, voltage of the ECM IDLO terminal is 3.4 V or more for 3 seconds or more.
  1. Open or short in idle control circuit
  2. ECM

WIRING DIAGRAM

C128786E01

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).


1. CHECK WIRE HARNESS (EDU - ECM)

  1. A128590E02
    Disconnect the B51 EDU connector.

  1. Disconnect the B32 ECM connector.

  1. Measure the resistance of the wire harness connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B51-2 (IJEN) - B32-62 (IDLO)
    Below 1 Ω
    B51-2 (IJEN) - B32-62 (IDLO) - Body ground
    10 kΩ or higher

  1. Reconnect the EDU connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. REPLACE EDU
  1. Replace the EDU (Click here).


NEXT


3. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Clear DTCs (Click here).

  1. Start the engine and drive the vehicle for approximately 15 minutes.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    P1625
    A
    No output
    B



OK
SYSTEM IS OK
NG

REPLACE ECM


← P1625 Idle Signal Transmitter Circuit (Nov 2005 – Dec 2006)P2002 Particulate Trap Efficiency Below Threshold (Bank1) (from Nov 2005) →