Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006from Jan 2007
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.
REMOVE FRONT WIPER ARM HEAD CAP
Remove the 2 caps.
3.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the nut and arm and blade.
4.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Remove the nut and arm and blade.
5.
REMOVE FRONT FENDER TO COWL SIDE SEAL LH
Detach the claw and remove the front fender to cowl side seal.
6.
REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Detach the claw and remove the front fender to cowl side seal.
7.
REMOVE COWL TOP VENTILATOR LOUVER
Remove the 2 clips.
Detach the 12 claws and remove the louver.
8.
REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Remove the 2 bolts.
Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor and link.
Disconnect the connector and detach the clamp.
9.
REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY
Detach the claws and remove the ventilator housing.
10.
REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY
Remove the 14 bolts and cowl top panel outer.
11.
REMOVE COWL BODY MOUNTING REINFORCEMENT LH
Remove the 2 nuts and mounting reinforcement.
12.
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Remove the 2 screws.
Detach the 2 claws and remove the instrument panel under cover.
13.
REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)
Remove the 4 bolts and driver side knee airbag.
Disconnect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.