2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE FRONT WIPER ARM HEAD CAP
  1. Remove the 2 caps.


3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

B131452
  1. Remove the nut and arm and blade.


4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

B131474
  1. Remove the nut and arm and blade.


5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH

E125248E01
  1. Detach the claw and remove the front fender to cowl side seal.


6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

B133588
  1. Detach the claw and remove the front fender to cowl side seal.


7. REMOVE COWL TOP VENTILATOR LOUVER

B131453
  1. Remove the 2 clips.

  1. Detach the 12 claws and remove the louver.


8. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

B131454E01
  1. Remove the 2 bolts.

  1. Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor and link.

  1. Disconnect the connector and detach the clamp.


9. REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY

B134570
  1. Detach the claws and remove the ventilator housing.


10. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY

B134568
  1. Remove the 14 bolts and cowl top panel outer.


11. REMOVE COWL BODY MOUNTING REINFORCEMENT LH

B134569E02
  1. Remove the 2 nuts and mounting reinforcement.


12. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

B129996
  1. Remove the 2 screws.

  1. Detach the 2 claws and remove the instrument panel under cover.


13. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)

B127987
  1. Remove the 4 bolts and driver side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


14. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

B132919
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.

    HINT:
    Tape the screwdriver tip before use.


15. DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

C132127
  1. Remove the clip and pin, and disconnect the push rod clevis from the clutch pedal.


16. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.


17. DISCONNECT CLUTCH RESERVOIR TUBE

C127490
  1. Loosen the clip and disconnect the tube from the clutch master cylinder.

    HINT:
    Use a container to catch the fluid.


18. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C127491
  1. Using SST, disconnect the flexible hose tube.

    SST
    09023-00101  

    HINT:
    Use a container to catch the fluid.


19. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
  1. Remove the 2 nuts and clutch master cylinder.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →