REMOVAL
Removal / installation · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. TEST ROOF HEADLINING ASSEMBLY |
Short body:
Remove the roof headlining (Click here).
Long body:
Remove the roof headlining (Click here).
| 3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH |




Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Shot body:
Remove the 9 bolts and curtain shield airbag.
Long body:
Remove the 10 bolts and curtain shield airbag.
| 4. REMOVE ROOF SIDE RAIL BRACKET LH |
Remove the 2 bolt and bracket.

