REMOVAL
Removal / installation · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE FRONT DOOR SCUFF PLATE LH
|
 |
- Using a screwdriver, detach the 10 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE REAR DOOR SCUFF PLATE LH (for Short Body)
|
 |
- Using a screwdriver, detach the 8 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)
|
 |
Using a screwdriver, detach the 9 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 2 clips and remove the garnish.
| 5.
REMOVE CENTER PILLAR GARNISH LOWER LH
|
 |
- Remove the lap belt outer anchor cover.
Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.
- Using a screwdriver, detach the 2 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 2 clips and remove the garnish.
| 6.
REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH |
 |
Disconnect the connector.
Remove the bolt and sensor.