2005-2008 RAV4 · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

  1. B130255
    Attach the claws to install the moulding.

    HINT:
    Confirm that the moulding is firmly installed.


2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 6 claws to install the weatherstrip inner.

  1. B133485
    Attach the 2 claws to install the inside handle.

  1. B137875E01
    for 8 Clip Type:
    Attach the 8 clips to install the trim board.

  1. for 7 Clip Type:
    Attach the 7 clips to install the trim board.

  1. Install the 3 screws.

  1. B129164
    Attach the 3 claws to install the door inside handle bezel plug.

  1. B130017
    Attach the 12 claws to install the door assist grip cover.


3. INSTALL REAR DOOR ARMREST BASE PANEL UPPER LH

  1. B133495
    Attach the 2 claws and install the power window regulator switch to the panel.

  1. Connect the switch connector.

  1. B133496
    Attach the clip and 5 claws to install the panel (with the switch).


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →