2005-2008 RAV4 · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE REAR DOOR ARMREST BASE PANEL UPPER LH

  1. B130016
    Using a screwdriver, detach the clip, 5 claws, and remove the panel (with switch).

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connectors.

  1. B130015
    Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful when detaching the claws as the switch may fall and become damaged.


3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B130017
    Using a screwdriver, detach the 12 claws and remove the door assist grip cover.

    HINT:
    Tape the screwdriver tip before use.

  1. B129164
    Using a screwdriver, detach the 3 claws and remove the door inside handle bezel plug.

    HINT:
    Tape the screwdriver tip before use.

  1. B137876E01
    Remove the 3 screws.

  1. for 8 Clip Type:
    Using a screwdriver, detach the 8 clips, 2 claws and remove the trim.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. for 7 Clip Type:
    Using a screwdriver, detach the 7 clips, 2 claws and remove the trim.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. Using a screwdriver, detach the 6 claws and remove the weatherstrip inner.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

  1. B130254E01
    Put protective tape under the belt moulding.

  1. Using a moulding remover, detach the claws to remove the belt moulding as shown in the illustration.

    HINT:
    Tape the remover tip before use.

    NOTICE:
    Be careful when removing the belt moulding as there are claws attached to the front and rear ends of the belt moulding.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →