2005-2008 RAV4 · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. When installing the moulding, heat the vehicle body and moulding using a heat light.

    Standard heating temperature:
    Item
    Specified Condition
    Vehicle body
    40 to 60°C (104 to 140°F)
    Moulding
    20 to 30°C (68 to 86°F)

    NOTICE:
    Do not heat the vehicle body and moulding excessively.


1. INSTALL NO. 1 ROCKER PANEL MOULDING RETAINER

  1. B133715
    Install the 2 retainers with the 4 screws.


2. INSTALL QUARTER OPENING RETAINER LH

  1. B133714
    Install the retainer with the 4 screws.


3. INSTALL NO. 2 ROCKER PANEL MOULDING RETAINER

  1. B133713
    Install the retainer with the 2 screws.


4. INSTALL REAR QUARTER OUTSIDE MOULDING LH

  1. B136805
    Attach the 5 clips to install the moulding.

  1. B133709
    Using an air riveter or hand riveter with a nose piece, strike 2 rivets to the vehicle to install the rear quarter outside moulding to the vehicle.

    NOTICE:
    1. If the rivet is not positioned perpendicularly, it will bend the mandrel.

    2. B078874E01
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    3. B078875E01
      Confirm that the rivets are seated properly against the moulding. Do not tilt the riveter when installing the rivet to the moulding. Do not leave any space between the rivet head and moulding.

    4. B078876E01
      Do not leave any space between the moulding and door panel. Firmly hold together the 2 items while installing the rivet.


5. INSTALL NO. 1 REAR WHEEL OPENING EXTENSION LH

  1. B136804
    B133205
    Attach the 5 clips to install the extension.
    Using an air riveter or hand riveter with a nose piece, strike 2 rivets to the vehicle to install the rear wheel opening extension to the vehicle.

    NOTICE:
    1. If the rivet is not positioned perpendicularly, it will bend the mandrel.

    2. B078874E01
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    3. B078875E01
      Confirm that the rivets are seated properly against the moulding. Do not tilt the riveter when installing the rivet to the moulding. Do not leave any space between the rivet head and moulding.

    4. B078876E01
      Do not leave any space between the moulding and door panel. Firmly hold together the 2 items while installing the rivet.


6. INSTALL NO. 2 REAR WHEEL OPENING EXTENSION LH
  1. Attach the 2 claws to install the extension.

  1. B136808
    Install the screw.


7. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH

  1. B136809
    Attach the 9 clips to install the extension

  1. Install the 4 screws and 2 clip.

← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →