ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| REMOVE NO. 1 ENGINE COVER
|
 |
- Detach the 4 clips and remove the engine cover.
| INSPECT INJECTOR ASSEMBLY |
 |
- Disconnect the injector connector.
Measure the resistance.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
1 - 2
|
20°C (68°F)
|
0.9 to 1.1 MΩ
|
- HINT:
- The temperature indicated in "Condition" is the temperature of the injector assembly.
If the result is not as specified, replace the injector assembly.
Connect the injector connector.
| INSTALL NO. 1 ENGINE COVER
|
 |
- Attach the 4 clips to install the engine cover.