2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


3. REMOVE AIR CLEANER ASSEMBLY

  1. A124927E01
    Disconnect the mass air flow meter connector.

  1. Unhook the 3 hook clamps.

  1. Disengage the wire harness clamp.

  1. A126824
    Using pliers, grip the claws of the clip and slide the clip to disconnect the PCV hose from the cylinder head cover.

  1. Using pliers, grip the claws of the clip to remove the air cleaner cap.

  1. Remove the air filter element.

  1. A124928E01
    Disconnect the wire harness clamp and remove the 3 bolts and air cleaner case.


4. DISCONNECT ENGINE WIRE
  1. Disconnect the fuel pressure sensor connector.

  1. Disconnect the pressure discharge valve connector.

  1. Disconnect the turbo pressure sensor connector.

  1. Remove the grommet and nut and disconnect the wire harness.

  1. Remove the 2 nuts and disconnect the engine wire from the engine cover bracket.


5. REMOVE INJECTION PIPE SUB-ASSEMBLY

NOTICE:
After removing the fuel pipe, to prevent dirt or foreign objects from entering the pipe inlet, cover the common rail with electrical tape. Also protect the injector inlets with electrical tape or plastic bags.

  1. A110775E02
    Remove the 2 bolts and 4 injection pipe clamps.

  1. Using SST, loosen the 4 nuts at the common rail end of the injection pipes.

    SST
    09023-38401  

  1. Using SST, loosen the 4 nuts at the injector end of the injection pipes.

    SST
    09023-38401  

  1. Remove the 4 injection pipes.


6. REMOVE NO. 1 NOZZLE LEAKAGE PIPE ASSEMBLY

  1. A117983E02
    Remove the fuel check valve, bolt and gasket.

  1. A110781
    Remove the 4 union bolts, 4 gaskets and No. 1 nozzle leakage pipe.


7. REMOVE NOZZLE HOLDER CLAMP NO.1

  1. A110777
    Disconnect the 4 injector connectors.

  1. A114890
    Using a hexagon socket wrench, remove the 4 bolts.

  1. A110792
    Remove the 4 bolts, 4 washers and 4 nozzle holder clamps.


8. REMOVE INJECTOR ASSEMBLY
  1. Remove the 4 injectors and 4 injection nozzle seats from the cylinder head.

  1. Remove the O-rings from each injector.

    NOTICE:
    When removing the injector assembly, store them in the correct order so that they can be returned to their original locations when reassembling.

← ON-VEHICLE INSPECTION (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →