REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1.
REMOVE REAR WIPER BLADE ASSEMBLY |
 |
- Rotate and remove the cap as described in the "REMOVE" procedures.
Raise the arm and blade.
- Raise the wiper blade to the position where the claw detach with a ''click'' sound, as shown in the illustration.
- NOTICE:
- Be careful not to damage the claw.
- Pull the wiper blade straight toward the left side of the vehicle to remove it from the wiper arm.
- NOTICE:
- Do not fold the wiper arm with the wiper blade removed. The arm tip may damage the back door glass surface.
| 2.
REMOVE REAR WIPER RUBBER |
 |
Lift and pull the end of the wiper rubber protruding from the blade stopper as shown in the illustration.
- NOTICE:
- Do not forcibly pull out the wiper rubber. The backing plates will be deformed or the blade claws will be damaged.
- HINT:
- Lightly pushing the rubber between the ends and middle will allow it to be removed more easily.