2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL REAR WIPER MOTOR ASSEMBLY

B131460
  1. Install the wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.


2. INSTALL REAR WIPER MOTOR GROMMET

3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
  1. Stop the wiper motor at the automatic stop position.

  1. B117856E02
    Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.

  1. E125268E03
    Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    1. Hold down the arm hinge by hand while tightening the nut.
    2. Install the arm and blade so that the rear wiper blade is aligned with the defogger line.

  1. B136379
    Install the cap.


4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
  1. Install the back door trim pocket with the 5 screws.

  1. B129943
    Attach the 13 clips to install the trim board.


5. INSTALL BACK DOOR SIDE GARNISH RH

HINT:
Use the same procedures described for the LH side.


6. INSTALL BACK DOOR SIDE GARNISH LH

  1. B129945
    Attach the 2 claws and 2 clips to install the garnish.


7. INSTALL BACK DOOR CENTER GARNISH

  1. B129944
    Attach the 4 claws and 4 clips to install the garnish.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →