REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE BACK DOOR CENTER GARNISH |
Using a screwdriver, detach the 4 claws and 4 clips and remove the garnish.

- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE BACK DOOR SIDE GARNISH LH |
Using a screwdriver, detach the 2 claws and 2 clips and remove the garnish.

| 4. REMOVE BACK DOOR SIDE GARNISH RH |
- HINT:
- Use the same procedures described for the LH side.
| 5. REMOVE BACK DOOR TRIM BOARD |
Using a screwdriver, detach the 13 clips and remove the trim board.

- HINT:
- Tape the screwdriver tip before use.
- If the screwdriver cannot reach the clips, pull on the lower trim to remove it.
- Tape the screwdriver tip before use.
Remove the 5 screws and the back door trim pocket.
| 6. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY |
Widen each end of the cap 5 mm (0.19in).

Lift the both widened ends of the cap.

Rotate the cap. Fix the cap in place.

Remove the nut and arm and blade.

| 7. REMOVE REAR WIPER MOTOR GROMMET |
| 8. REMOVE REAR WIPER MOTOR ASSEMBLY |
![]() ![]() |
Disconnect the connector.
Remove the 3 bolts and wiper motor.

