2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1451/51 Compressor Solenoid Circuit

Diagnostic trouble codes · Vehicles built Nov 2005 – Jul 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007

DESCRIPTION

In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier.
Based on this signal, the compressor changes the degree of refrigerant compression.
DTC No.
DTC Detection Condition
Trouble Area
B1451/51
Open or short in solenoid of externally changeable compressor circuit
  1. Compressor and pulley
  2. Harness and connector between air conditioning amplifier and compressor and pulley
  3. Air conditioning amplifier

WIRING DIAGRAM

E115016E05

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (REG CTRL CURRNT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.

  1. Select the items below in the Data List, and read the value displayed on the intelligent tester.

    Air conditioning amplifier:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Reg Ctrl Currnt
    Regulator control current /
    Min.: 0 A
    Max.: 0.997 A
    Value changes between 0 A and 0.997 A in accordance with compressor and magnetic clutch operation
    -

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE AIR CONDITIONING AMPLIFIER
A


2. INSPECT COMPRESSOR AND PULLEY
E115015E06
  1. Disconnect the compressor and pulley connector.

  1. Measure the resistance of the connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SOL-) - 2 (SOL+)
    25°C (77°F)
    10.1 to 11.1 Ω



NG
REPLACE COMPRESSOR AND PULLEY
OK


3. CHECK WIRE HARNESS (COMPRESSOR AND PULLEY - AIR CONDITIONING AMPLIFIER)
E115955E04
  1. Disconnect the B23 compressor and pulley connector.

  1. Disconnect the E41 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B23-2 (SOL+) - E41-2 (SOL+)
    Below 1 Ω
    B23-2 (SOL+) - Body Ground
    1 MΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK WIRE HARNESS (COMPRESSOR AND PULLEY - BODY GROUND)
E119774E02
  1. Disconnect the B23 compressor and pulley connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    B23-1 (SOL-) - Body Ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) (from Nov 2005)B1451/51 Compressor Solenoid Circuit (from Aug 2007) →